top of page
Week 12
This week I continued to work on my bottle cap, by first printing it and testing it out. The threads were the tricky part because to get them on the bottle fully was a big challenge. So from the first print I found out that I made the bottle cap too small and it didnt fit on at all. So then I went back to SolidWorks and fixed up my measurements again. So then I printed another cap and this time the size was good but the cap itself looked too thick. While working on the bottle cap, I also worked on my actual sharpner. I decided to make it round so it would fit and look better on the bottle cap.
bottom of page